環氧地坪漆中涂層位于底涂層和面涂層之間，主要是用來找平地面、進一步穩固基面，增加環氧地坪涂層厚度、提高漆膜的耐沖擊抗耐磨能力。環氧地坪漆中涂層施工主要包括中涂砂漿層和膩子層，需要在底漆層完全干透之后才能進行施工。下面環氧地坪漆廠家就給大家詳細介紹環氧地坪漆中涂施工方法。

The coatings in epoxy floor paint are located between the bottom coatings and the surface coatings. They are mainly used to leveling the ground, further stabilizing the base surface, increasing the thickness of the epoxy floor coatings and improving the impact resistance and wear resistance of the paint film. The coating construction of epoxy floor paint mainly includes intermediate mortar layer and putty layer, which need to be completely dried before construction. The following epoxy floor paint manufacturers will give you a detailed description of the epoxy floor paint coating construction methods.

環氧地坪漆中涂層的作用：

The role of coatings in epoxy floor paint:

1、增強耐磨性能：環氧地坪漆是固化成膜類環氧地坪漆，它是通過在混凝土表面形成保護涂膜來完成它的保護使命，中涂就是夾在底漆和面漆中間，提高環氧環氧地坪工程耐磨性能，使用年限的關鍵;

1. Enhance wear resistance: Epoxy floor paint is a kind of cured film-forming floor paint. It completes its protection mission by forming a protective coating on the surface of concrete. Intermediate coating is sandwiched between primer and topcoat to improve the wear resistance of epoxy floor engineering and the key to its service life.

2、增加厚度：一般的地坪漆底漆和面漆施工后，只會產生0.2-0.5mm的涂層，這樣不僅耐磨很差，還給人們走在上面的體驗很差。

2. Increase the thickness: After the construction of general floor primer and topcoat, only 0.2-0.5mm coating will be produced, which not only has poor wear resistance, but also gives people a poor experience of walking on it.

3、降低成本：由于中涂層不需要承擔防護各種有害物質侵害的任務，那對它的要求實際上是可以降低一點點的。而且中涂層是在環氧地坪涂層的中間，五顏六色沒人能看到，于是色粉可以省掉。所以中涂一般會比面漆和底漆來得便宜。

3. Cost reduction: As the intermediate coating does not need to undertake the task of protecting against harmful substances, its requirements can actually be reduced a little. And the middle coating is in the middle of the epoxy floor coating, colorful no one can see, so the color powder can be omitted. So middle coatings are generally cheaper than topcoats and primers.

4、找平地面：通常情況下，環氧地坪施工基層的混凝土地面是不夠平整的，特別是地面上的小坑洞、裂縫，如果不經過中涂砂漿的灌輸及中涂膩子的填補，是很難做到理想效果的，尤其是當上了環氧面漆以后，在亮麗的地面上，那些丑陋的缺陷將會展現無疑。

4. Leveling the ground: Usually, the concrete ground of the epoxy floor construction base is not smooth enough, especially the small holes and cracks on the ground. It is very difficult to achieve the ideal effect without the filling of middle-coated mortar and putty. Especially when the epoxy top coat is applied, the ugly defects will undoubtedly appear on the bright ground. 環氧地坪漆中涂刮涂施工

Scraping Construction of Epoxy Floor Paint

環氧地坪漆中涂砂漿層施工方法：

Construction method of mortar layer in epoxy floor paint:

(1)在底漆完全干透之后，再按照中涂漆的比例進行配比，并加入適量的40-100目石英砂及少量的石英粉進行攪拌，然后用批刀整體批刮1-2遍，確保無漏除和堆積等現象。

(1) After the primer is completely dried out, it is proportioned according to the proportion of middle paint, and a suitable amount of 40-100 mesh quartz sand and a small amount of quartz powder are added to mix, then scraped 1-2 times with batch knife to ensure that there is no leakage and accumulation.

(2)由于砂漿層表面較粗糙，孔隙較多，一般需刮膩子找平，填補空隙。中涂砂漿層完工以后一般需要打磨、吸塵，再中涂膩子層。

(2) Because the surface of mortar layer is rough and there are many voids, it is usually necessary to scrape putty to level and fill the voids. After finishing the middle coated mortar layer, it usually needs to be polished, cleaned, and then coated with putty layer.環氧地坪漆中涂膩子層層施工方法：

Construction method of putty layer in epoxy floor paint:

在中涂砂漿層自然干透后，按照中涂漆的配比，加入適量石英粉(膩子粉)攪拌均勻。用平刀整體批刮1-2遍，不得存在漏除和堆積等現象。在具體的施工過程中，應選擇施工性能比較好的膩子，即良好的刮涂性和填平性，適宜的干燥性，耐打磨。因為中涂膩子層是為面漆的施工做鋪墊，膩子層的好壞直接影響地坪漆的表面效果，因此要求膩子層批刮好后表面必須光滑、平整無刮刀痕、無任何顆粒。

After the mortar layer is naturally dried out, according to the proportion of the middle paint, add appropriate amount of quartz powder (putty powder) and mix evenly. Use flat knife to scrape the whole batch for 1-2 times. There should be no leakage and accumulation. In the concrete construction process, putty with good construction performance should be selected, that is, good scraping and filling, suitable dryness and grinding resistance. Because the middle-coated putty layer is to pave the way for the construction of topcoat, the quality of putty layer directly affects the surface effect of floor paint, so it is required that the surface of the batch-scraped putty layer must be smooth, flat, without scratch marks, and without any particles.

環氧地坪漆施工效果

Construction effect of epoxy floor paint

環氧地坪漆中涂施工注意事項：

Points for Attention in Intermediate Painting Construction of Epoxy Floor Paint:

1、選擇的環氧中涂需要與所用的底漆和面漆配套。

1. Selected epoxy coating needs to be matched with the primer and topcoat used.

2、根據客戶要求的施工厚度和產品干燥性能控制好每道涂層的厚度，不能一道施工過厚，否則有可能出現因溶劑揮發困難導致涂層長時間發軟，不但延誤工期，而且涂層固化性能差。

2. The thickness of each coating should be well controlled according to the customer's requirement and the drying performance of the product. It should not be too thick together. Otherwise, the coating may be softened for a long time due to the difficulty of solvent volatilization, which not only delays the construction period, but also leads to poor curing performance of the coating.

3、選擇合適的膩子，要有良好的施工性能，即良好的刮涂性和填平性，適宜的干燥性，耐打磨。

3. Choosing suitable putty should have good construction performance, that is, good scraping and filling, suitable dryness and grinding resistance.

4、因為中涂膩子層是為面漆的施工做鋪墊，膩子層的好壞直接影響的表面效果，因此要求膩子層批刮好后表面必須光滑、平整無刮刀痕、無任何顆粒。

4. Because the middle-coated putty layer is to pave the way for the construction of topcoat, the quality of putty layer directly affects the surface effect, so it is required that the surface of the putty layer after batch scraping must be smooth, flat, without scratch marks, and without any particles.